Used to break loose old drain fittings and supply connections that have been in place for decades without rounding the nuts.
Bathtub installation Cleburne TX done right the first time
If you need bathtub installation Cleburne TX homeowners can count on, we set the tub, tie in the drain and supply lines, and test every joint before the surround goes back up.
Serving cleburne and nearby areas.
How big is the job?
Drain move
New tub needs the drain relocated or the subfloor repaired
- 1. Direct swap Same size tub, drain lines up, sound subfloor
- 2. Drain move New tub needs the drain relocated or the subfloor repaired
- 3. Full rough-in Freestanding tub, new drain cut, floor reinforcement planned in writing first
Drag the needle to compareTouch and drag the needle
- 30Services from one local team
- 20Areas served around cleburne
- Measure twiceAlcove checked before the tub is ordered
- Test firstFull tub of water before sealing
What our bathtub installation includes
Every install covers the labor and standard materials to remove the old tub, set the new one, and connect it to your existing plumbing.

Work order
Bathtub Installation- Old tub removal: We disconnect the supply lines, cut the caulk line, and pull the old tub. Cast iron comes out in sections. The unit goes on our truck and off your property the same day.
- Subfloor inspection: We check the subfloor and joists for soft spots and water damage. Rotten plywood gets replaced before the new tub is set, so the base is solid and level.
- Drain and overflow connection: We install a new drain shoe, overflow gasket, and P-trap connection. Every joint is tested with a full tub of water before the surround goes back up.
- Supply line hookup: We connect the tub filler to your existing supply lines using PEX pipe or copper pipe, with new fittings and Teflon tape on the threads. No reused washers or old seals.
- Level set and seal: The tub is set on a mortar bed or foam base, leveled front to back and side to side, then sealed at the floor and wall line with silicone. A level tub drains fully.
- Cleanup and haul-away: We bag the debris, wipe down the surfaces, and take the old tub and packaging with us. You are left with a working tub and a clean bathroom floor.
What the first visit covers
First visit
We measure the alcove or floor space, check the drain location and subfloor, and confirm what will fit through the door.
Bathtub installation at Cleburne homes
We install tubs in houses across Cleburne, from pier-and-beam to slab.
Alcove tub swap
Same-size replacement, drain reused if sound
Freestanding tub set
New drain cut and floor-mounted filler
Cast iron removal
Cut into sections and hauled off
Subfloor repair
Soft plywood replaced before the tub is set

Bathtub installation for Cleburne properties
We handle tub installs for rental and multi-unit properties in and around Cleburne.
Rental units
Durable tubs that clean easily between tenants
Small motels
Standard alcove swaps done on a schedule
Multi-unit housing
Repeat installs with consistent drain work
What bathtub installation Cleburne TX really involves
A tub that is set level and sealed correctly lasts for decades. One that is rushed leaks into the floor and costs far more to fix. We do the drain and the base right the first time.
Bathtub installation Cleburne TX is the removal of an existing tub or the setting of a new one, plus the drain, overflow, supply lines, and surround work that make it usable. We cut the old unit out, check the subfloor and joists, dry-fit the new tub, then connect a new wax ring-free drain assembly, PEX or copper supply lines, and a code-correct P-trap. Every joint gets tested before the wall closes back up.
Most Cleburne calls come from two situations: a cracked or stained tub in a 1970s ranch house, or a builder-grade tub in a newer subdivision that flexes underfoot. If you have been searching bathtub installation near me Cleburne TX because water is pooling at the base, that is usually a failed seal or a drain shoe that has rusted through. We fix the cause, not just the symptom.

- What it is
- Removing an old tub and setting a new one
- When it helps
- Cracks, flexing, rust stains, or slow drains
- What you get
- Level tub, new drain, full leak test
How our bathtub installation process works
Five steps, one crew, and a clear timeline. Here is exactly what happens from the first phone call to the final walkthrough.
Tools and methods we use on every tub install
Each method answers a different question. Together they leave very little to guess.
Makes secure, code-approved connections on PEX pipe when we run new supply lines to the tub filler.
Used for copper pipe supply connections where the existing lines are copper and need a new fitting.
Clears soap scum and hair from the branch line while the tub is out, so the new drain starts clear.
Blasts heavy buildup from the drain line when a snake is not enough, restoring full flow before the new tub is set.
When Cleburne homeowners book a tub install
A 1960s ranch home near the Cleburne Historic District has a cast iron tub with a rusted drain and a soft floor around it.
We cut the cast iron out in sections, replace the rotten subfloor, correct the drain height, and set a new acrylic alcove…
HomesA newer home in Buffalo Creek has a builder-grade tub that flexes and has cracked the caulk line twice.
We pull the flexing tub, check the subfloor, and set a rigid acrylic model on a foam base.
HomesA homeowner near Lake Pat Cleburne wants to swap a garden tub for a freestanding model in a different spot.
We core the slab for the new drain, run the line to the existing branch, install a floor-mounted filler, and reinforce the…
HomesA rental property in North Cleburne has a tub with a persistent slow drain and a stained surface.
We snake and jet the branch line, replace the drain shoe and overflow, and install a new tub with a finish that…
Businesses
How bathtub installation runs in Cleburne
Cleburne has two very different housing stocks, and they change how we install a tub. Homes near Downtown Cleburne and the Cleburne Historic District are often pier-and-beam with cast iron drains and older galvanized supply lines.
Cleburne Historic District
Older pier-and-beam homes with cast iron drains and narrow doorways. We measure the path before bringing a tub in and often remove the old unit in sections.
Buffalo Creek
Newer slab homes with PVC drains. Builder-grade tubs here often flex, so we set the replacement on a foam base to stop movement.
Lake Pat Cleburne
Homes near the lake can have higher humidity, which shows up as mildew at the tub caulk line. We use a mold-resistant silicone and seal the floor line fully.

- Cleburne Historic District
- Buffalo Creek
- Lake Pat Cleburne
- North Cleburne
From problem to finished result.
Slide to compare the photo with an illustrative inspection view. It is generated from the photo, not a measurement.
PhotoCast iron swap in a historic district home
Before: A 1962 ranch home near the Cleburne Historic District had a cast iron tub with a rusted drain shoe and soft plywood around the base. Water had been seeping into the floor for years.
After: We cut the cast iron out in sections, replaced the subfloor, corrected the drain height, and set a new acrylic tub on a mortar bed. The full-tub test held with no drips. Job took one day.
Freestanding tub on a slab in Buffalo Creek
Before: A homeowner in Buffalo Creek wanted a freestanding tub where a garden tub had been, but the drain was in the wrong spot and the floor was not reinforced for the weight.
After: We cored the slab for a new drain, tied into the existing branch line, reinforced the floor, and set the freestanding tub with a floor-mounted filler. The old garden tub was hauled off the same day.
Builder-grade tub replacement in Sunset Heights
Before: A 2015 home in Sunset Heights had a builder-grade tub that flexed underfoot and had cracked the caulk line twice. The drain was slow and the surface was stained.
After: We pulled the flexing tub, snaked and jetted the branch line, set a rigid acrylic model on a foam base, and resealed the surround. The tub holds water with no movement and drains clear.
Problems a new tub solves for Cleburne homes
Most tubs do not fail suddenly. They crack, flex, stain, or leak slowly until the damage shows up somewhere else.
Cracked or flexing tub shell
A flexing tub breaks the caulk seal and lets water into the subfloor. Over a year or two, that rots joists and stains the ceiling below.
Rust stains and a failing drain shoe
A rusted drain shoe drips constantly into the floor cavity. The stain on the tub is the visible sign; the hidden damage is underneath.
Tub too shallow for the household
A builder-grade tub that holds 30 gallons does not work for soaking. Homeowners end up avoiding the tub entirely, which wastes the space.
Slow drain that backs up into the tub
When the branch line or main is blocked, water backs up into the tub and leaves a ring of debris. It gets worse with every use.
Why homeowners upgrade their tub
A new tub is not just cosmetic. It stops hidden leaks, restores resale value, and gives you a surface you can actually clean.
Leaks stopped at the source
A tub that flexes cracks the caulk line and lets water into the subfloor.
Water use cut by gallons
Older tubs hold 50 to 60 gallons. A modern 60-inch alcove tub holds 30 to 42.
Cleaner lines, fewer clogs
While the tub is out, we run a drain snake or hydro jetting machine through the branch line and check the P-trap for buildup.
A floor that stays dry
We check the subfloor for soft spots, replace any rotten plywood, and set the tub level front to back and side to side.
What you receive on install day
Clear records you can keep and share.
Written price
Given after we measure and check the drain
Leak test record
Full tub of water checked before sealing
Haul-away receipt
Old tub removed from the property same day
16 years of tub installs in Johnson County
Cleburne Trailcrest Plumbing has been setting tubs since 2010, which means we have opened walls in nearly every era of home this town has.

Drain height
Measured against the new tub outlet so the P-trap lines up without stress on the joint
Subfloor moisture
Checked with a meter and by probing for soft wood before the tub is set
Supply pressure
Read on a gauge after hookup to confirm the new valve and lines hold and flow correctly
Is your Cleburne address covered?
Type your ZIP code or town to check. If you're not listed, call and ask.
cleburne ZIP codes
- 76033
- 76031
Towns we serve.
Based in cleburne and covering the places around it. Pick one for local details.
What Cleburne homeowners say
Our 1970s tub had a crack that was leaking into the ceiling below. The crew cut it out, found soft subfloor, replaced the plywood, and set a new acrylic tub on a mortar bed. They tested it with a full tub of water before sealing. No more stain on the ceiling. Took about six hours.
We wanted a freestanding tub in a spot that had no drain. They cored the slab, ran the drain, and set a floor-mounted filler. I was worried it would not line up, but they measured twice and it fit perfectly. The old garden tub was gone the same day.
Booked a same day bathtub installation and they actually showed up when they said. Pulled the old steel tub, snaked the drain while it was open, and had the new one sealed by mid-afternoon. Price matched the quote. I have already recommended them to a neighbor.
Frequently Asked Questions
Short answers for the first few minutes. The team can cover the rest.
Describe what you are seeing and we will point you to the right next step.
(682) 468-2111If the subfloor is rotten or the drain needs to move, that adds labor.
A standard alcove swap takes four to seven hours, so most jobs are done in one day. If we have to move the drain, replace subfloor, or cut a new opening for a freestanding tub, plan on two days. We give you the timeline before we start so you can plan around it.
Yes. Removal and disposal are part of the price. We cut cast iron tubs into sections, carry them out, and take them with us. You do not need to rent a dumpster or schedule a bulk pickup. The old tub is gone the same day the new one goes in.
Yes, and we do them often. A freestanding tub needs a floor-mounted or wall-mounted filler, a drain that lines up with the tub's outlet, and sometimes a reinforced floor. On slab homes we core the concrete for the drain and tie into the existing line. We measure before you buy so the tub fits the space and the plumbing.
Book your bathtub installation Cleburne TX today
(682) 468-2111We give you a written price the same day, set the tub level, and test every joint before we leave. Old tub hauled off, new one ready to use.
Contact Cleburne Trailcrest Plumbing
Call us at (682) 468-2111 or email [email protected]. We answer the phone Monday through Friday, 8 a.m. to 6 p.m., and we run emergency calls after hours. If you leave a message, we call back the same day. Tell us what you're seeing and we'll tell you what it likely is and when we can get there.









